MDP Supplies
Shopping Currency
 
Fret Cut Sign Tray Fabrication
Fret Cut Sign Trays from MDP Supplies

MDP Supplies now offers a service to the trade for fret cut sign trays (folded pans).

Manufactured from 3mm aluminium composite and available in a range of colours and finishes, the sign trays provide a robust, long lasting signage solution for exterior use. We can provide them with LED illumination and offer them with 3 finishing options for the cut-outs.

Use the quote system below to get a price and add this to your order. Then just pay online and we will produce and despatch your job within 48 hours.

If you have any queries please email fabrication@mdpsupplies.co.uk or call 0151 272 2021.

Fret cut trays with back panels are despatched fully assembled. Face Only trays are supplied flat to reduce the risk of damage in transit, for installation instructions click here.

Custom Fret Cut Sign Tray
1

Dimensions

Specify the sizing of the face of the sign tray and enter the depth of the return.

Alternate Text

Maximum width
There is no maximum width but trays widths (inc returns) greater than the following have to be manufactured as multiple panels. These are supplied with tongue & groove joining strips for on-site application.
Standard colours - 3000mm
Special finish colours - 2400mm


Maximum height
Due to the sheet size the following are maximum heights (inc returns) for panels
Standard colours - 1460mm
Special finish colours - 1200mm

Depth
As standard the depth of the return is 85mm. This can be enlarged but we recommend that it should be a minimum of 75mm to prevent spotting of the LEDs.


Width mm Height mm Depth mm
2

Select The Colour

Choose the colour of the aluminum composite. Click help for colour chart.


Standard colours available in matt or gloss finish.
Aluminium Composite colours available
3

Fret Cut Areas

Specify the size of each fret cut area.
If there is more than one area click the + icon to add more areas.


In the example below there are 2 fret cut areas, the main 'Shop Sign' text sized at 1070 x 210mm and the strapline text which is sized at 1625 x 100mm.
Give each of the 2 sections an identifiable name, eg for the first one 'Shop Sign', enter the dimensions of the area and type of cut out finishing required, then click the + icon. Then repeat for the second section, eg. call this 'Strapline', enter the dimensions and the type of cut out finishing required and then click the + icon again.



We offer 3 different types of finishing for the cut outs, recessed, flush or raised.

The opal acrylic is fitted to the reverse of the sign tray face giving the lettering a recessed look. 5mm opal acrylic is used so it is nearly flush with the tray face. Using 10mm opal acrylic the letters protrude out approximately 5mm from the sign tray face.

Fret cut areas will be filled with opal acrylic as standard. You can specify an alternative acrylic colour fill, without additional cost. Specific fill colour requests must be emailed within 1 hour of placing your job order.
Fret Cut Area    
Width mm           Height mm    
Cut Out Finishing  
4

Backing Panel / Illumination

The tray can be supplied with a pre-installed LED backing panel or just as a face if
installing onto an existing light box.


If this is a new sign installation we can provide a full backing panel with aluminium angle and pre-installed LEDS with power suppy ready for installation.

We use LEDs with Samsung chips and CE approved IP67 power supplies.

Where the face of the sign is being fitted onto an existing light box then select Face Only.

Costings

Based on the information entered above the price for the manufacture of the fret cut sign tray is shown below.

£0.00

Latest Products
New Products
MDP Branches
Store Locations
Your Trolley

Your Trolley Is Empty

Payment Methods
Payment Methods